Introduction
The Lean Vendor series (LV2018, LV2018S, LV2018P) vending machines are robust, user-friendly systems engineered for dispensing snacks and beverages. This guide offers a detailed overview of installation, operation, maintenance, and troubleshooting procedures to optimize performance.
Specifications
Physical Dimensions:
- Height: 72” (1,829 mm)
- Width: 39” (991 mm)
- Depth: 34” (864 mm)
- Weight: 877 lbs. (398 kg)
Electrical Requirements:
- USA/Canada: 120V AC, 60Hz, Single Phase
- Europe/Other Countries: 220/230/240V AC, 50Hz
Storage Capacity:
- Selections: 18
Installation and Setup
Receiving and Unpacking:
- Inspect the machine for shipping damage and report immediately to the carrier.
- Unpack carefully and retain the packaging during the warranty period.
Placement:
- Place the machine on a solid, level surface capable of supporting 1,200 lbs (544 kg).
- Ensure at least 2 inches of clearance behind the machine for proper ventilation.
Electrical Connection:
- Plug directly into a grounded outlet with a dedicated circuit breaker. Avoid using extension cords.
Leveling:
- Adjust the leveling legs using a 1½-inch wrench. Ensure the machine is level both front-to-back and side-to-side.
Operation
Loading Products:
- Snack Trays: Load items horizontally and ensure alignment for proper vending. Use spacers as needed for smaller products.
- Beverage Columns: Use accessories like spacers and auger inserts for secure placement. Test vend after loading.
Programming:Access the service menu by pressing the Menu button on the Vending Machine Controller (VMC).
Common Programming Options:
- Price Settings: Configure pricing for individual items or all selections.
- Sales Tracking: View historical and interval sales counters.
- Time Programming: Schedule operational times and vending hours.
Maintenance
Daily Tasks:
- Clean the exterior and product doors with a damp cloth.
- Inspect the coin and bill acceptors for jams or debris.
Weekly Tasks:
- Remove and clean product chutes and display brackets.
- Clean the condenser fins with canned air or a soft brush.
Refrigeration Maintenance:
- Ensure vents are clear of dust and debris.
- Disconnect the refrigeration system for deeper cleaning and service if required.
Troubleshooting
| Issue | Possible Cause | Solution |
| No power | Faulty power supply | Check outlet and power cord connections. |
| Product not vending | Item misaligned or motor issue | Re-align product; test motor in Service Mode. |
| Incorrect change dispensed | Coin mechanism error | Clear jam; reset coin mechanism. |
| Refrigeration not cooling | Dirty condenser or faulty compressor | Clean condenser; call support if issue persists. |
For more details, consult the complete manual available at Seaga Manuals.
For immediate support, contact [email protected] or call 1-815-297-9500.