Introduction
The S50 Bottle Chest Cooler by Seaga India is engineered for compact storage of beverages, offering efficient cooling, durable construction, and ease of maintenance. This guide outlines the key specifications, setup process, usage tips, and troubleshooting methods.
Specifications
Physical Characteristics:
- Height: 615 mm
- Width: 750 mm
- Depth: 510 mm
- Weight: 32 kg
- Capacity: 50 liters
Refrigeration:
- Compressor: Hermetically sealed
- Refrigerant: R134a
- Temperature Control: Thermostat
Electrical Requirements:
- Voltage: 230V AC ±10%, Single Phase, 50Hz
- Amperage: 1.5A
Environmental Conditions:
- Maximum Ambient Temperature: 41°C
- Relative Humidity: 75%
Installation
Steps for Installation:
- Unpacking:
- Placement:
- Power Setup:
- Pre-Operation:
Operating Instructions
- Place bottles vertically to ensure optimal air circulation.
- Keep the door closed as much as possible to maintain cooling efficiency.
- Avoid overloading the cooler to prevent cooling inefficiencies.
Maintenance
Defrosting:
- The cooler defrosts automatically with each thermostat cycle. If manual defrosting is needed, turn off the power and allow frost to melt naturally.
Cleaning:
- Clean the interior and exterior using a soft cloth dipped in warm water with a pinch of baking soda. Avoid using soap or harsh detergents.
Troubleshooting
| Issue | Cause | Solution |
| Cooler not running | No power supply or loose connections | Check the power source and secure connections. |
| Insufficient cooling | Open door or gasket misalignment | Close the door and adjust or replace the gasket. |
| Noise during operation | Cooler not leveled or loose components | Level the cooler and tighten screws. |
| No cooling | Compressor or fan failure | Contact technical support for assistance. |
For additional support, contact:
- Email:
- Phone: +91-1276-268122
For the full manual, visit: Seaga Manuals.